![]() ![]() If you had little working at that moment, with few resources being used, for example, then waking up should be quick however if you had a lot of items open, and were using a lot of resources at the time you enabled Sleep or Hibernation, then waking up could take a while since there's a lot more for the system to rekindle and recover before activity can commence again. With Sleep and Hibernation Modes, the speed of reawakening often depends on what you had open at the time you put the system into Sleep or Hibernation. Shutdown is exactly that - powering down the computer fully. Sleep and Hibernate Modes are both settings aimed at keeping your sessions active while you are away from your desk, with Hibernation being a deeper version of Sleep. Why?Ī: Most Windows machines allow for three means of system-based slumber: Sleep Mode, Hibernation Mode and Full Shutdown Mode. Microsoft then started to distribute early Windows10 versions without paying money for it, but with digital license, so I created/used that in a new virtual machine and that still works, including updates.Q: I have a Windows 10 computer and whenever I wake my system from Sleep Mode it seems to take forever before I can actually start doing anything on it. ![]() The laptop is very slow and Windows/Microsoft more or less pushes you to upgrade sometime in the future so I managed to pull an image from the PC's harddisk and got that running in a VirtualBox virtual machine on my main work computer. Via a TIL111 I have it done in the past, then it is isolated as well, but you probably don't need that.īut I choose another way to handle this problem. I don't have a pico, but ESP's and Arduino's that can then do something to get it started. If I wanted a solution for the laptop, I would solder something (2 wires) in parallel to the power or sleep button. I have a 'broken lid laptop', a PC that doesn't support Wake-on-LAN and I need Windows every now and then. My laptop is a Acer Aspire A315-42-R9NG (It does not have the wake on charger plugged in setting in BIOS) Is there a way to wake up my laptop using the pico? But every time I want to start, I have to open the lid and the lid mechanism is broken, so I want to avoid touching/using the lid. So I use my Windows laptop as a stationary computer. I got a MacBook and use it as my main laptop. SImplest way to do this would probably be to find an old, cheap USB keyboard with the right key/button present then perform surgery on it so only that button is present. IIRC, the OS and controller on the USB host also have to support USB wake and have it enabled (which probably measn enabling wake on PCI/PCIe too). I couldn't get my head fully around this hence my not suggesting it. So you may need both remote-wakeup to get the usb to start checking for HID reports, and then send an HID report with the power keyĪnd the bios will need to be configured to wake when the power key on a usb keyboard is pressed Re-reading the usb2 specs, i think that remote wakeup-signal is only to get the usb bus out of sleep mode, so you can then send usb packets once more So in theory, you just set that remote resume bit, and the host wakes up SIE_CTRL.RESUME), where the device initiates the resume. ![]() The USB device controller supports both suspend and resume, as well as remote resume (triggered with ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |